Hi, As I was driving a few days ago my trajet went into Safe mode(which is only on 3rd. gear). I drove home and seach in this forum and found that usually the input sensor is the problem also advice me not to drive the car. The next day I sent the Hyundai ppl to my place to check with the scanner and found error code P0755 and P0760 which is the Solenoid valve. They took out the soleoid valve and found that 1 solenoid valve O-ring was not properly but why show 2 error code and they advice me to change all the Solenoid valve as the trajet is 6 years old. I cannot understand why the O-ring became like this after few years. Please advice (Pic. attached). Tks

This post has been edited by Explorer 1: Jul 6 2008, 07:31 AM

Hi Explorer 1

I had to replace the 'OD" solenoid , I did it myself . it is not a stright forward

type of job , but not that much diffecult . the wire inside the solenoid opened

and can actually be tested from the wires connector up the A/T . the O ring

story is not convencing , what moves an O ring ?? .

I paid 65 JD (usd 90 ) for the new one . by the way all 5 solenoids

inside the A/T are of the same type and interchangable .


Regards