i have a 2006 gt tiburon and im new to the forum. I honestly got this account specifically because i really need help hooking up my subs. anyone who has hooked up subs to there tiburon please help me out. im car retarded and i need help step by step. PLEASE HELP

What are you trying to hook the sub up to? ie, do you still have the factory stereo installed? or have you replaced the head unit and added an amp to power the sub.

We just installed a nice little stereo in my girlfriends tiburon. Typically the setup that you'd want to aim for is head unit connected to amplifier 1 (4 channel). Amplifier 1 then runs the 4 front and rear speakers. Headunit also connected up to amplifier 2 (2 channel or 1 channel). Amp 2 then runs the sub of choice. If it's a 2 channel amp, then the single sub should be run in bridged mode, whereby the positive lead is connected to the positive terminal for channel 1 and the negative lead is connected to the negative terminal of channel 2 (or vise versa).

Unless you have problems that are tiburon specific, I suggest you find a car audio forum and post there as well as these forums seem to be quite quiet. With my girlfriends tiburons, we wanted to put the amps under the front seats but they wouldn't fit. As such they're both mounted on backside of the rear seats, and a 15" such sits in the boot. It all sounds very nice.

i have the stock everything still in it. its all infiniti even the one speaker in the trunk. Im unsure about where the stock amp is actually located tho. i took the cover off what i thought was the amp in the trunk, but it was just a speaker. Can you tell me where the amp is? that would help alot

Just replaced the factory amp in my car with an aftermarket one yesterday, so I know this one. The amplifier is located below the rear speaker (the one located in the backseat, not the trunk) on the drivers side. Once you take the side panel off it will be mounted lengthwise to the frame of the car.

This post has been edited by djclue8713: Aug 22 2008, 04:40 PM